ADAPTERS for SLOTTERS

SQUARE ADAPTER FOR SLOTTERS
SQUARE ADAPTER FOR SLOTTERS

 

PRISMATIC ADAPTER FOR SLOTTERS
PRISMATIC ADAPTER FOR SLOTTERS

 

The square and prismatic adapters are equipped with two threaded holes where the two M12x8 flat point grub screws are inserted and used to clamp the tool to the inside of the said adapters. The timing pin guarantees a perfect position of the tool in relation to the work axis.
Both the square and prismatic adapters are available in two measurements: with a hole diameter of 25 mm and another measuring 32 mm.
REV offers the solution of clamping the tool on with an adapter; however, this is only one of the many ways it is possible to set up the REV Broaching Tool on slotting and shaping machines.